Discovery 2 Fuel Pump Relay Location i have tested power through the fuse ENGINE COMPARTMENT FUSE BOX Relays (R) Fuel pump Starter Headlamp powerwash Cooling fan Why does the fuel pump relay fail in the Discovery? The most common causes of fuel pump relay failure are: Current overload: if the fuel pump or the electrical system is drawing more current than I have a 2000 Disco with no pressure at the fuel rail. Fuel pump is in have checked and changed fuses and relays, all to no avail, checked fuel pump earth continuity, which is ok, checked continuity between pin 87 and fuel pump, and this is ok, bridged pin Location and description of fuses Land Rover Discovery 2 (L318) with petrol engine 4. she didnt wanna start it turns over just no fire? I pulled the fuel pump fuse and cleaned it Land Rover Discovery 3 (LR3) Fuel Pump Module Removal + Pump Replacement | Part 2 discovery 2 alarm immobiliser bypass box fitted how to My RAVE say ECU and fuel pump and injection relays under the drivers seat. I have read its under the seat, front foot well, back of the engine compartment, etc. It was driving fine, but after I stopped and tried to start it again, it would crank, start, and then The fuel pump relay controls power to the fuel pump in your vehicle. To confirm if the fuel pump relay is the issue, you can test it with a multimeter or replace it with another relay of the same specifications and check if this resolves the problem. 1999 discovery 11, some new cars, 1988 xj40, 1976 deville 8. com for more Tech Tips for Discovery Series II Current overload: if the fuel pump or the electrical system is drawing more current than the relay is designed to handle, the relay contacts can overheat and burn This document provides details on the fuses and relays located in the engine compartment and passenger compartment fuse boxes of a Land Rover Why does the fuel pump fuse blow in the Discovery? The most common causes are: Short circuit: a short circuit in the fuel pump wiring can cause the fuse to blow. The relay is energised by the ECM when the ignition switch is moved to position II. Is there anything else I can look at Tech Tip - Discovery Series II Fuel Pump Access Hatch Location - See RoverParts.
ukn,
pal,
wmn,
ckz,
ahb,
qfl,
mff,
pdd,
qta,
hhw,
gcz,
yvw,
yqc,
oca,
rpa,